Edelbrock 1 Bar Delco Manifold Absolute Pressure (Map) Sensor - 36019

Edelbrock Pro-Flo 4 EFI System for Chevrolet LS GEN III/IV engines. The EFI system comes with a traditional 4150-Style satin finish Victor Jr. cathedral port intake & 35 Lb/Hr injectors capable of 550 HP with 58 p.s.i. fuel pressure.Warranty

Edelbrock 2 Bar Map Sensor w/ 1/8 -27 NPT - 36020

Edelbrock Pro-Flo 4 EFI System for Chevrolet LS GEN III/IV engines. The EFI system comes with a traditional 4150-Style satin finish Victor Jr. rectangle port intake and 35 Lb/Hr injectors capable of 550 HP with 58 p.s.i. fuel pressure.Installation...

Edelbrock Air Temperature Sensor and Grommet - 3578

This Wide Band Air/Fuel Ratio interface unit will not only work with all current EFI systems, but with any aftermarket EFI system that can accept a 0-5 volt input for monitoring Air Fuel Ratios.Warranty

Edelbrock DeLPHi Fluid Temperature Sensor - 36012

Performer RPM Q-JET Marine Intake Manifold For 1996+ Small-Block Chevrolet 262-400 V8's with E-Tec or Vortec Heads. Cooling Water Passages are Lined with Brass to Prevent Corrosion. Carb Pads Accept Q-Jet or Square-Bore Marine Carburetors.Warranty

Edelbrock EFI 02 Sensor and Bung - 3591

This Air/Fuel Monitor displays the actual air/fuel mixture in ratios from approximately 12 to 15:1. Use it to guide carburetor adjustment and jetting or to improve ignition spark advance curves. Not for use with leaded fuels or alcohol.Warranty

Edelbrock EFI Air Temp Sensor - 3588

Performer RPM Q-JET Marine Intake Manifold For 1986 & Earlier Small-Block Chevrolet 262-400 V8's. All Cooling Water Passages are Lined with Brass to Prevent Corrosion. The Carb Pads Accept Either Q-Jet or Square-Bore Marine Carburetors.Warranty

Edelbrock EFI Coolant Temp Sensor - 3589

Performer RPM Q-JET Marine Intake Manifold For 1987-95 Small-Block Chevrolet 262-400 V8's. All Cooling Water Passages are Lined with Brass to Prevent Corrosion. The Carb Pads Accept Either Q-Jet or Square-Bore Marine Carburetors.Warranty

Edelbrock EFI Map Sensor - 3587

Edelbrock Pro-Flo 4 EFI System for Chevrolet LS GEN III/IV engines. The EFI system comes with a 4150-Style satin finish Victor Jr. cathedral port intake manifold and 29 Lb/Hr injectors capable of 450 HP with 58 p.s.i. fuel pressure.Warranty

Edelbrock EFI Pump Relay - 3586

This Wide Band Air/Fuel Ratio interface unit will not only work with all current EFI systems, but with any aftermarket EFI system that can accept a 0-5 volt input for monitoring Air Fuel Ratios.Warranty

Edelbrock Ford Coyote 5.0L Pro-Flo 4 Plus Knock Sensor Harness - 36125

When choosing to upgrade your engine to modern fuel injection, look no further than Edelbrock's Pro-Flo 4 EFI systems. Edelbrock has been delivering the best combination of dyno proven electronic fuel injection performance for over 40 years. Pro-Flo 4 is...

Edelbrock Ford Modular 2V High Output Coil-On-Plug (COP) - 22744

This Max-Fire Coil-On-Plug ignition coil pack is for use with 1997-2014 Ford 4.6L, 5.4L and 6.8L engines with 2-valve cylinder heads. It's a direct bolt-on with OEM DIS electronic controls and aftermarket high performance ignition systems. Its designed...

Edelbrock GM Stepper Iac Motor - 36015

Edelbrock idle air control motors control idle speed by regulating the flow of air around your throttle plates for proper performance. Edelbrock offers these idle air control motors for a variety of EFI systems. They're constructed from top-quality...